Reaper action strings how to#

Reaper action strings how to#

As pointed out in the comments, my pickup height was actually adjustable, I just wasn't aware of how to do it. Turns out the bridge height was, which is what caused the issue. Initially I didn't suspect it was a pickup distance issue as my pickup height is not adjustable. After lowering this and checking the volume I found it to be back to normal. This probably caused the strings to be far away from the pickups, so the volume was less. I found that my action adjustment on my bridge was a bit higher on the High E string side than the Low E string side.

I changed my strings to a new set because earlier it was a mix of different string gauges. Thanks everyone for the suggestions, some of them helped. I fixed my issue, thought I would post my solution here in case anyone faces a similar issue. I changed my strings to a new set, theres a lesser difference now, but its still there, if Im picking with the same force, the low E string gives a -12dB output but the high E string gives -18dB output. I even plugged in my guitar to my Zoom G3X processor and the issue exists here as well, so the issue is probably with my guitar and not my interface. I checked Reaper, and even tried Audacity, this issue persists on both of them. I haven't changed my strings in a few months, so could that also be a cause? I read in some places that it could be because the pickups need to be remagnetized.

If I increase the input volume on the Solo, the parts with the low string starts clipping.Д«ecause of the lower volume on the high strings, tapping and hammer on and pull offs don't sound clear. When I record my guitar, the input volume from the lower E string is much more than the high E string. I noticed this recently, as I got a Scarlett Solo interface. Ive been facing some issues when recording with my Ibanez GRG 170DX.